How to Refinish a Vintage Metallic Glider

Aged metallic patio home furniture has normally been repainted more than when, and if you never like the nation primitive glance it will need to have to be refinished. This is a good task for do-it-yourselfers who like to save revenue and get satisfaction of taking a little something old and creating it look new.

If you under no circumstances have restored a vintage porch glider, it really is genuinely fun. I will inform you some of the items I tried using and failed to like and some of the matters that labored for me.

In this article is my disclaimer: this is info on how I refinished a patio glider. You are dependable for your individual safety. Don basic safety equipment.

For the best looking vintage glider all the previous paint has to come OFF to the metallic. First I tried paint stripper, but it just gums up the paint and designed a large mess so I moved on to a little something else pretty swiftly. For starters I use a four inch grinder with coarse sand paper. You go in excess of the entire glider but be watchful not to put as well a lot tension on the grinder specifically on the bottom of the seat down towards where your ft rest. That is the initially spot to rust on these previous gliders and if you are not cautious you will knock a hole in it.

The coarse sand paper receives off the most important element of the paint but in the corners of the structure, these kinds of as the Pie Crust design, there is some paint left that demands to occur off. They make a sanding wheel that appears like a flat Brillo pad that will suit on the 4″ sander and this operates nicely eliminating the paint in the corners.

Following you get all the paint taken out wipe the dust off the glider with a tiny mineral spirits.

Now you are ready to paint your glider. I like to paint the gliders I am performing on two tone. I am going to get about 10 spray cans of grey primer, about 10 cans coloured spray paint, about 5 cans of white and about 4 spray cans of apparent paint, and a couple of rolls of masking tape.

I initially paint the glider all more than with the primer and let it dry about an hour, then I mask off the white regions of the bench, and then spray the color. I clear away the masking tape as soon as I am by way of portray (if the paint was dry when the tape was eradicated the paint could chip).

After the colored paint is dry I mask off the coloured paint large ample not to get any white in excess of spray on the coloration paint. As quickly as I end with the white paint I take out the masking tape and spray the obvious coat on. I commonly put about a few coats of clear coat for that deep seem.

Perfectly which is it! Soon after a couple of hrs you have a pleasant piece of out door furniture.